Ag(I) complexes with alkylidene-bis(2-aminopyrimidines) as building units for discrete metallomacrocyclic frames. A structural and solution study

Alkylidene-bis(2-aminopyrimidines) (pyr2Cx, x = 2-5) are useful ligands to interact with Ag(I) yielding discrete metallocycles. Crystal structures of the [(pyr2C2)Ag(NO3)]2 and [(H-pyr2C4)Ag(NO3)2]2 have been isolated where each macrocyclic moiety interacts with their surroundings through weak interactions, yielding 3D discrete structures, On the other hand, the solution study shows that the equilibrium constants for the formation of Ag(pyr2Cx)+ complexes are higher than the literature values for Ag(I) complexes with single pyrimidines, although the differences could be explained by invoking the solid-state structures of the Ag(I)-pyr2Cx complexes.     

A new approach to qualitative analysis of organophosphorus pesticide residues in cucumber using a double gas chromatographic system: GC-pulsed-flame photometry and retention time locking GC-mass spectrometry

A qualitative method for the screening of organophosphorus pesticides (OPs) that could present in different types of vegetables has been established and validated. A typical multi-residue extraction procedure of OPs using ethyl acetate and sodium sulphate has been applied. No clean-up was required after extraction, and concentrated extracts were analysed by gas chromatography with pulsed-flame photometric detection (GC-PFPD). Confirmation of compound identities was performed by gas chromatography with mass spectrometric detection (GC-MSD) in the electron impact (EI) mode with full scan acquisition. Retention time locking (RTL) software was used in order to improve the method capability of identification and confirmation. Spiked samples at pesticide concentrations equal to the maximum residue level (MRL) were used to check chromatographic performance and for validation studies. The proposed method allows a rapid and accurate identification of the studied OPs until the ng ml(-1) range for those whose use is forbidden, and above their MRL concentration for the rest.     

Simple and rapid determination of the drug naproxen in pharmaceutical preparations by heavy atom-induced room temperature phosphorescence

A simple, selective and sensitive heavy atom-induced room temperature phosphorimetric method (HAI-RTP) is described for the determination of naproxen (NAP) in pharmaceutical preparations. The phosphorescence signals are a consequence of intermolecular protection when analytes are, exclusively, in presence of a heavy atom salt and sodium sulfite as an oxygen scavenger to minimize RTP quenching. These variables selection constitute the basis of a HAI-RTP method for the determination of naproxen (detection limit 17.6 ng ml(-1); 1.71% relative standard deviation at 250 ng ml(-1)). The method has been applied satisfactorily to the analysis of pharmaceutical preparations.     

Y-shaped two-photon absorbing molecules with an imidazole-thiazole core

Two new classes of two-photon absorbing Y-shaped molecules have been developed to possess an imidazole-thiazole core and a stilbene-type conjugation pathway with either nitro or sulfonyl as terminal electron-accepting group.     

A scaled quantum mechanical force field for the sulfuryl halides. I. The symmetric halides SO2X2 (X=F, Cl, Br)

Force fields and vibrational wavenumbers were calculated for the molecules SO2X2 (X=F, Cl, Br) using DFT techniques. The previously available experimental data and assignments for SO2F2 and SO2Cl2 were compared with the theoretical results and revised, and new low temperature infrared and Raman data were obtained for SO2Cl2. These data were subsequently used in the definition of scaled quantum mechanics force fields for such molecules. Adjusted wavenumbers were also predicted for the still unknown SO2Br2. A comparison is made with results published for the VO2X2- anions.     

Kinetic study in water-ethylene glycol cationic, zwitterionic, nonionic, and anionic micellar solutions

The spontaneous hydrolysis of phenyl chloroformate was studied in water-ethylene glycol, EG, cationic, zwitterionic, nonionic, and anionic micellar solutions, the surfactants being tetradecyltrimethylammonium bromide, tetradecyl-N,N-dimethyl-3-ammonio-1-propanesulfonate, tricosaoxyethylene glycol ether, and sodium dodecyl sulfate. The dependence of the observed rate constant on surfactant concentration as well as on the percentage by weight of EG, varying from 0 to 50 wt %, was investigated. Information about changes in the critical micelle concentrations, in the micellar ionization degrees (for ionic surfactants), in the aggregation numbers, and in the polarity of the interfacial region of the micelles upon changing the weight percent of EG was obtained through conductivity, surface tension, spectroscopic, and fluorescence measurements. A simple pseudophase model was adequate to rationalize the kinetic data. Micellar medium effects were explained by considering charge-charge interactions and polarity, ionic strength, and water content in the micellar interfacial region. The acceleration of the reaction produced by an increase in the amount of EG present in the mixture was explained on the basis of the substantial decrease in the equilibrium binding constant of phenyl chloroformate molecules to the micelles, resulting in the contribution of the reaction taking place in the bulk water-EG phase being more important. The weight percent of EG did not substantially influence the rate constant in the micellar pseudophase.     

Spectroscopic and photochemical properties of the lichen compound lobaric acid

Lichens synthesize and accumulate photoprotective compounds against possible damage induced by UV radiation in the photobiont. A biological model has been recently formulated that allows the use of lichens to evaluate changes at different UV radiation levels. The thermodynamics, photophysical and photochemical properties of lobaric acid were studied in acetonitrile, ethanol and Brij 35(3%) micelles at different pH values. Also the sun protector factor (SPF) was determined by in vitro methods. Lobaric acid was extracted from Stereoculon alpinum Laur. and characterized by means of standard procedures. Solutions were irradiated in oxygen and under nitrogen conditions with a UV medium pressure lamp. Lobaric acid absorbs at 287, 303 nm, and no fluorescence emission was observed. The maximum value of the molar extinction coefficient (5479.6 M(-1) cm(-1)) was obtained in Brij 35 at pH 12. Solubility is pH dependant and is highest in Brij 35 at pH 12 (4.45 x 10(-4) M). Photoconsumption quantum yields ranged between 10(-4) and 10(-5) in aerobic and anaerobic experimental conditions. Lobaric acid SPF was very low (0.5) compared with homosalate (4.0), (reference solar filter). Two pKa values, 5.05 (carboxylic acid group deprotonation) and 9.75 (phenolic OH deprotonation), were determined.     

Certain graphs with exactly one irreducible T-module with endpoint 1, which is thin

Journal of Algebraic Combinatorics - Let $$\Gamma $$ denote a finite, simple and connected graph. Fix a vertex x of $$\Gamma $$ and let $$T=T(x)$$ denote the Terwilliger algebra of $$\Gamma $$ with...     

Comparative voltammetric study of 2,4-dinitrophenol (DNP), albumin and DNP-albumin as an analytical approach to the use of DNP as a universal label in immunoelectrochemical assays

A comparative electrochemical study of 2,4-dinitrophenol (DNP), albumin and DNP-albumin has been carried out at a hanging mercury drop electrode, in order to use DNP as a universal label in immunoelectrical assays. Several electrochemical techniques have been used. Differential pulse voltammetry has proved to be the most suitable. Wide dynamic linear ranges (more than three orders of magnitude for DNP-albumin) and low detection limits have been achieved (5 x 10(-10)M, 2 x 10(-10)M, 3 x 10(-12)M for DNP, albumin and DNP-albumin, respectively). Good reproducibility has been obtained in all cases (R.S.D. < 2.2%).     

Temperature dependence of the Mössbauer spectra of amorphous and nanocrystallized Fe86Zr7Cu1B6

Mössbauer measurements have been performed on amorphous and nanocrystalline alloy ribbons of nominal composition Fe₈₆Zr₇Cu₁B₆. The nanocrystalline samples were obtained by annealing the as-quenched alloy at different temperatures in the range between 650 and 870 K. Mössbauer spectra of the as-quenched amorphous sample have been recorded at 77 K, room temperature and above the Curie temperature (330 K) at 360 K. We have also performed Mössbauer measurements at room temperature in the nanocrystalline alloys to characterize the phases that appear after the annealing and their relative concentration. The as-quenched sample spectra reveal the existence of two inequivalent sites for Fe. Such a feature is also observed in the remaining amorphous phase of the annealed samples. In the first steps of crystallization, -Fe precipitates and its concentration increases with the annealing temperature. The experimental results suggest that the composition of the whole amorphous phase does not suffer large changes during crystallization.